Know How | FlexForm™ Stand

The FlexForm™ Stand can be configured for a laptop, tablet, or phone. This guide explains how to unfold the stand, choose the right support mode, position your device, adjust the viewing angle, and fold the stand for storage.

Know the Parts of the FlexForm™ Stand

The stand uses an aluminum-alloy main frame with adjustable support arms, support feet, device stoppers, and silicone anti-slip contact points. An adjustment block controls the available positions, while the included hex keys can be used for minor tension adjustments when required.

How Do You Set Up the FlexForm™ Stand?

FlexForm™ supports three practical configurations. Choose the mode that matches the device you are using, then make small adjustments to the height and angle after the device is in place.

Mode 1: Laptop Setup

1. Rotate the support arms and support feet outward until the base is open and balanced.
2. Raise the support structure and select one of the six available adjustment levels.
3. Extend both device stoppers so they can support the lower edge of the laptop.
4. Place the laptop centrally on the stand.
5. Check that the laptop rests evenly against both sides before adjusting the final height or angle.

Mode 2: Phone Setup

1. Open the rear support leg and place the stand on a flat, stable surface.
2. Select a viewing angle that keeps the stand balanced.
3. Flip out the device stopper.
4. Place the phone centrally against the support surface.
5. Confirm that the phone and any protective case sit securely within the stopper.

Mode 3: Tablet Setup

1. Open the rear support leg and set the initial viewing angle.
2. Extend the device stoppers and support arms for a wider support area.
3. Place the tablet centrally on the stand.
4. Fine-tune the angle and height while keeping the tablet supported with one hand.
5. Make sure the tablet is stable before use, especially when tapping or drawing on the screen.

How Do You Adjust the Height and Viewing Angle?

The FlexForm™ Stand provides six adjustment levels, a support height range of 58–130 mm, and working angles from 12° to 31°. Start with a lower position, place the device on the stand, and then adjust one level at a time.

Keep one hand on the device whenever you change the position. The stand should remain fully supported by its feet, with the device centered between the left and right support points.

How Do You Fold and Store the Stand?

1. Remove the device before folding or adjusting the stand.
2. Return the support structure to its lowest position.
3. Fold the device stoppers and support arms inward.
4. Rotate the support feet back into the main frame.
5. Check that all moving sections sit flat before placing the stand in a drawer or bag.

When folded, the stand measures 149 × 82 × 11 mm and weighs approximately 295 g. Store it separately from items that could press against the hinges or scratch the aluminum surface.

FlexForm™ Stand Specifications

Care and Safe Use

• Place the stand on a flat and stable surface before adding a device.
• Keep the device centered within the support area.
• Do not adjust or fold the stand while a device is resting on it.
• Check that the stoppers and support feet are fully extended before use.
• Use a soft, dry cloth to clean the aluminum and silicone contact areas.
• If a joint requires adjustment, use the included hex key in small increments and avoid overtightening.
• Compatibility can vary with unusually thick, heavy, or irregularly shaped protective cases.